Abstract: Sometimes its necessary to perform a factory reset from a HomeMatic IP device. The following steps are required.

Steps to perform a factory reset:

1.) Remove batteries from the device / remove the device from power by unplugging it
2.) Press and hold the system button on the device
3.) Put the batteries back in the device (do not release the system button during this action!) / plug the device into a power socket (do not release the system button during this action!)
4.) Wait until the system button starts flashing
5.) Keep the button pressed for 4 seconds, then release the system button (if you see a red light something went wrong)
6.) After you released the button press it again for around 4 seconds (it should glow green)

Quelle

Comments (4)

  1. andystone269@gmail.com

Thanks for posting this. Your blog is so interesting and very informative. Thanks sharing. Definitely a great piece of work. Thanks for your work.

  1. James

It is one of the best information which you are providing. I love your blog because it totally full of informative posts. You are nice one and thanks for sharing.

  1. James

Your blog is very nice and interesting.Keep up the good work.

  1. Henry

Thanks for your post. I'm sure many others will find it interesting because it's about a widely discussed topic. Your content is explained in much better way. Thanks so much for your post.

There are no comments posted here yet

Leave your comments

Posting comment as a guest.
Attachments (0 / 3)
Share Your Location